65
5.3
Daily check
Perform the following checks before using the lift.
1. Check all stickers for damage and legibility. Replace as necessary. See section ”6
Marking” on page 69.
2.
Check flags for damage. Replace as necessary. See section ”6.7 Warning flags” on
page 74.
3. Check the warning lights (accessory) for function and damage. See section ”3.10.5
Warning lighting (accessory)” on page 24. Contact a qualified service engineer for
troubleshooting or repair.
4. Check two-handed operation for function; see section ”3.10.1 Two-handed operation”
on page 24.
Contact a qualified
service engineer for troubleshooting or repair.
5. Look beneath the tail lift to check for oil leaks.
Contact a qualified
service engineer for
troubleshooting or repair.
6. Visually inspect all tail lift components for cracks and deformations. Contact a quali-
fied
service engineer for troubleshooting or repair.
7. Check that the open platform alarm is working as intended. See section ”3.10.4 Open
platform alarm” on page 24
8. Check that the platform is clean and safe to access. Remove any snow, mud, dirt,
rubbish or slippery fluids. ZEPRO recommends the use of anti-slip safety shoes with
protective toecaps in accordance with EN ISO 20345. Risk of personal injury.
9. Check the wheel stops (accessory) for function and damage. Make sure that the wheel
stops do not jam, lubricate if necessary with thin penetrating oil. Also ensure that the
wheel stops remain in the fully raised position (mechanical stop) even if the platform
is subjected to strong vibration (similar to when heavy goods are rolled on and off the
platform). Contact a qualified service engineer for troubleshooting or repair.
Service and maintenance