©We reserve the right to change the specification without
notice
A
C/DC
zentro-elektrik GmbH KG
| Tel.: +49 (0) 72 32 / 3131 0 | Fax: +49 (0) 72 32 / 3131 399 | E-mail: [email protected]
DATASHEET / OPERATING INSTRUCTIONS
SELECTION TABLE OF ZAT1600 FEATURES
This table shows which
features are possible at the
same time.
IF N THEN then not possible.
T
r i
m
m
er
A
n
a
L
o
g
R
e
l
a
y
B
u
s
O
ut
B
u
s
I
n
T
e
m
p
S
e
n
s
e
C
o
d
e
S
w
i
t
c
h
Trimmer adjustment
N
N
N
N
Analog control (isolated)
N
N
N
N
Relay alarm
N
BusOut (RS-232 control to slave)
N
N
BusIn
N
N
N
Temp.comp.
N
N
Sense
Customised charging algorithm
chargers with code Switch
N
N
PIN CONFIGURATION, MODULAR CONNECTORS
Front panel
Rear panel
J1:
Analog input 0-5VDC
J3:
Temperature compensation, Sense option
J5:
RS-232 bus in and out, master-slave
Alternatively power fail relay alarm
OPTIONAL ALARM RELAY
If the unit is ordered with alarm relay (for example ZAT1600/24/60/H), the potential free alarm output indicates if the charger’s output
is healthy. The alarm signal is activated at AC fail and charger fail cases. Both normally open and normally closed signals are
presented.
Pin Configuration, Modular connector J5 with relay alarm option
MODULAR JACK
Front view
CABLE
Black = common
Red = NO
Green = NC
RELAY
Isolation:
Technical data:
Output to Case: 500V
1A @ 24Vdc
Output to GND: 120V
0,5A @ 120Vac
If power is off the COMMON is connected to NC
If power is on the COMMON is connected to NO