ZoningBOX 6 / ZoningBOX 4
Technical Support:
8
Zoning
[
disabled
/enabled
]:
enables o disables the “Zones” tab on the left
menu. See section 2.2 for more details.
Grille Control
[
enabled
]:
enables o disables the “Grilles” tab on the left
menu. See section 2.3 for more details.
Manual Control
[
disabled/
enabled
]: enables o disables the “Manual Control”
tab on the left menu. See section 0 for more details.
Sending of Indication Objects (0 and 1) on Bus Voltage Recovery
[
disabled
/enabled
]: this parameter lets the integrator activate two new
communication objects (“
Reset 0
” and “
Reset 1
”), which will be sent to the
KNX bus with values “0” and “1” respectively whenever the device begins
operation (for example, after a bus power failure). It is possible to
parameterise a certain
delay
[
0
…255
] to this sending.
Figure 4.
Sending of Indication objects on bus voltage recovery
Heartbeat (Periodical Alive Notification)
[
disabled
/enabled
]: this parameter
lets the integrator incorporate a one-
bit object to the project (“
[Heartbeat]
Object to Send ‘1’
”) that will be sent periodically with value “1” to notify that
the device is still working (
still alive
).
Figure 5
. Heartbeat (Periodical Alive Notification).
Note
:
The first sending after download or bus failure takes place with a delay of
up to 255 seconds, to prevent bus overload. The following sendings match the
period set
.
