Zennio Securel v2, User Manual

Page: 7 / 13

Securel v2
http://www.zennio.com Technical Support: http://support.zennio.com
7
2 PAIRING WITH IWAC
To make it possible the communication between IWAC and Securel v2, they must be
paired. The aim of the pairing is to ensure that the communication between these
devices is exclusive, this means, Securel v2 will only handle orders from the IWAC to
which is paired.
To pair a Securel v2 with an IWAC:
If Securel v2 has not been paired with any IWAC before , it will be in
pairing mode. Only connect the Securel v2 to the IWAC desired to pair with
and they will be automatically paired.
If Securel v2 is paired with an IWAC , press the programming button for
three seconds to remove the pairing. Securel v2 is then in pairing mode.
Connect the Securel v2 to the IWAC desired to pair with and they will be
automatically paired.
Notes :
Whenever Securel v2 is not paired, it will try to get paired by keeping the
pairing mode active.
While the device is in pairing mode no action can be performed in the output.
For more information of the LED status during pairing, see section 3.