Securel v2
Technical Support:
5
1.3
INSTALLATION
Securel v2 connects to the KNX bus through the on-board KNX connector. Moreover,
an
additional power supply
of 24 VDC is required.
Figure 2.
Securel v2.
Securel v2 is connected to the external power supply through any of its three positive
terminals (1) and any of its two neutral connectors (3).
On the other hand, Securel v2 powers the electric strike also using one of the other
positive supply terminals (1) and the terminal of the electric strike output as neutral (2).
Moreover, the relay also will power IWAC with 24VDC through its remaining terminals
(1) and (3).
Finally, the Securel v2 communicates with IWAC through the Tx/Rx transmit and
receive terminal (4).
It should be recalled that, in order to ensure the inviolability of our access control
system, it is necessary to locate Securel v2 inside the room of the management
module, establishing an encrypted communication with IWAC.
Figure 3 shows a connection diagram of IWAC, Securel v2, power supply and electric
strike:
3
2
6
4
5
1
7
1.
Auxiliary power supply.
2.
Electric strike output.
3.
Encrypted Communication.
4.
Programming Button.
5.
Programming LED.
6.
KNX Connector.
7.
Fixing clamp.
