ZENN
iO
AVANCE Y TECNOLOGÍA
www.zennio.com
1
0
Errors Management:
this functionality allows the sending of messages to
the bus informing about errors. Errors management handles Daikin error
codes as well as any communication errors that may arise
Besides informing about the apparition of possible errors it can be also
configured the sending of the error type.
In case of internal errors, the numerical code associated to the error type is
shown in the following table:
Error Number
Type of Internal Error
1
Problems with the data reception (speed, parity, etc.)
2
Communication waiting time exceeded (Time-out)
3
Incorrect checksum
4
Incorrect response from the machine
Regarding the numerical code associated to the external errors type, look
up the manual of the installed air-conditioning system or the
Annex II
Correspondence Error Codes of Daikin Units
.
Initial Configuration:
All machine status must have an initial value after installing the system or a
power failure. With this purpose, it has been included in the KLIC the
possibility of defining the initial status for the ON/OFF, temperature, fan and
speed of the machine.
These initial values can be sent both to the bus KNX and the air conditioning
unit.
Type of Control: Master/Slave
It is important to take into account the type of control,
master
or
slave
, with
which the KLIC-DI is going to be configured.
The remote control “master” in the installation is in charge of the
communication with the machine and it will retransmit the instructions and
status between the machine and the slave remote control in case of having
one. In spite of the master/salve configuration, all the functionalities can be
set from both remote controls.
This functionality allows including in the installation both
the KLIC-DI and the
Daikin wired control and choosing the desired master/slave configuration
whenever the KLIC-DI and the wired control are not configured with the
