IRSC Zone
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
9
3
ETS PARAMETRIZATION
To begin with the parameterization process of the IRSC controller it is necessary, once
the data base of the product (
IRSC Zone
application program) has been imported to
ETS, to add the device to the project where desired. After that, one right-click on the
device will permit selecting "Edit parameters", in order to start the configuration.
In the following sections a detailed explanation can be found about the different
functionalities of IRSC Zone available in ETS.
3.1
DEFAULT CONFIGURATION
This section shows the default configuration the device parameterization starts from for
the first time.
Figure 4.
IRSC Zone Default topology
The following communication objects appear: "
A/C Unit - ON/OFF status
", "
A/C Unit -
Setpoint status
" and "
A/C Unit - fan status
", all of which will report basic information
about the states of the A/C unit (ON/OFF, setpoint and fan speed).
Seven more objects, of different lengths, are shown, referred to different functionalities
that may be controlled for Zone 1 (Zone 1 is the only zone enabled by default). These
are (“X” means 1 here):
Zone X – ON/OFF
: permits turning ON or OFF each of the enabled zones
independently. Being ON implies a normal function of the zone, i.e., the
automatic control of its airing grille and the inclusion of its setpoint
temperature into the calculation process of the general setpoint temperature
sent to the air conditioning machine. On the other hand, when a zone is
