HeatingBOX
http://www.zennio.com
Technical Support:
http://support.zennio.com
19
Note
:
this option is only available if the
Notify When All Valves Are Closed
function has been enabled (see section 2.3).
Calculate the Max. Control Value
[
disabled/
enabled
]: when checked, the
current output will be taken into account to calculate the maximum control
value amongst all the outputs.
Note
:
this option is only available under a
one-byte
control and when the
Maximum Control Value
function has been enabled (see section 2.3).
Show Status Objects
[
disabled
/enabled
]: adds one or two (depending on the
control type) status objects to the project in relation to the control value.
“
[HCx] Control Value
– 1 bit (Status)
” (available in both, the one-bit and
the one-byte controls): it will send the value
“0” when the output closes and
the value “1” when it opens.
“
[HCx] Control Value
– 1 byte (Status)
” (only for the one-byte control): it
will send the current control value whenever it changes.
Note
:
this object corresponds to the input value of the characteristic curve
(value in the X axis), not to the output value. See section 2.4.1.5
Lock
[
disabled
/enabled
]: provides the
“
[HCx] Lock
” one-bit object, which
permits locking (with the value “1”) or unlocking (with the value “0”) the control
of the output. While locked, the output ignores any control commands.
When this function has been enabled, the following parameter appears:
Action
: sets an action to be performed by the output when it gets locked.
One-bit control
[
No Change
/ Close Valve / Open Valve
].
One-byte control
[
No Change
/ Specific Control Value
]. When selecting
the latter, the parameter
Control Value
[
0
…100
] lets introducing the
desired percentage value.
Alarms
[
disabled
/enabled
]: enables or disables the Alarm function. See section
2.4.1.2.
