Tudor - Installation & Operating Instructions - 85807 - June 2012 v1.00
Page 3
NOTE: Failure to correctly fit the Restrictaflow valve (provided) will void the warranty
Step One - Tapware
Note: Instructions for correct assembly and installation of Tudor tapware is included in
the tapware box. Pay close attention to these instructions.
Over-sink models must be installed with an inlet valve to control the flow from the water
supply to the heater. No valve is supplied with the heater. The water supply and valve should
be connected after fastening the heater to the wall.
Over-sink models are supplied with a 300 mm swivel spout. A 300 mm to 600 mm
telescopic swivel spout (99006NZ) is available as an optional extra.
Under-sink models must be installed with approved vented tapware. It is advisable to fit the
tap to the sink before mounting the heater to the wall beneath the sink.
1. Install the Restrictaflow valve provided, with the isolating valve (not supplied), into the
main cold water supply line. The Restrictaflow is adjustable and must be set to deliver no
more than 6Ltr/min (Max.)
NOTE:
Do not fit the Restrictaflow valve to the tank (See P.5 diag)
2. Flush water supply pipes thoroughly to remove any silt or fines.
3. Fasten the tap body to the sink using the bolt & plate system provided.
4. The hose with a WHITE band on it connects to the tap hole with NO marking.
5. The hose with a RED band on it connects to the tap hole with a RED marking.
6. The hose with a BLUE band on it connects to the tap hole with a BLUE marking.
7. Ensure that the flexible tubes are firmly attached to the base of the tap body and in the
correct sequence. Refer tapware installation sheet.
Do not dismantle the assembled tap body during installation. Mixer taps are factory tested
and sealed to provide optimum performance.
To adjust water temperature delivered by Solo and Hero mixer taps, see instructions on page
7. Such adjustments should be made only by a qualified technician.
Step Two - Positioning
Over-sink heaters should be installed so that the outlet spout drains to a sink or tub, and
with a clearance of 270 mm beneath the heater to allow for service access.
Under-sink heaters should be installed a closely as possible to directly below the outlet tap
with a clearance of 270 mm above the heater.
This unit must not be positioned in an area that may be cleaned by a water jet.
Step Three - Fastening
It is not necessary to remove the case of the heater during installation.
The heater must be wall mounted with two fixing screws as shown in the diagram on page
5. Fixing screws must have the strength to support the filled heater.
The fixing screws are to protrude 4 mm from the wall as shown in the diagram on page 5 so
as to fit into keyhole slots provided on the rear of the heater.
Installation Procedure
