6
598-1306-07
ENtrY SWItCH
Installation
Note:
Entry system includes a transmitter and magnet.
The system can be used to signal that a door or window
has been opened or to automatically turn the light on
when entering a closet, attic, room, etc.
1. Remove Tab from Battery Chamber. Remove transmitter back
cover from transmitter using small, flat-blade screwdriver. Gently
pull tab out of battery chamber.
Removing Battery Tab
Important Considerations:
• Entry transmitter components are for indoor use only.
• The transmitter should be mounted on the frame of door or
window (stationary surface). The magnet should be mounted
on door or window (moving surface). See illustration below for
mounting configurations and possible directions of movement.
CR2032
3 VOL
TS
Battery (Type
CR2032)
Transmitter
Tab
Flat-Head
Screwdriver
Possible Directions
of Movement
Possible Directions
of Movement
Possible Directions
of Movement
Possible Directions
of Movement
• A compatible receiver must be used to complete the system. The
receiver should be located within 100 feet (30 m) of transmitter
(maximum distance may vary depending on type of structures
between transmitter and receiver).
2. Select mounting location for entry transmitter.
Note:
Maximum
gap between transmitter and magnet is 3/8” and the arrows
located on the face of each component must be in alignment
(see illustration). Also, the front surfaces of the transmitter
and magnet must be flush. If magnet is recessed, use magnet
extension and two long screws (provided) to ensure proper
alignment.
Transmitter Mounted On Stationary Surface
Magnet Mounted On Moving Surface
Mounting Configurations and Possible Directions of
Movement
3/8" MAXIMUM
Possible directions of
Movement
Possible directions of
Movement
3. Before mounting, hold transmitter and magnet in selected
location and verify operation. While holding the transmitter
stationary, move the magnet away from transmitter to simulate
door or window being opened. Verify red LED on transmitter
flashes momentarily and receiver turns light on. Return magnet
to original position simulating door or window being closed.
Verify red LED on transmitter flashes momentarily and receiver
turns light off.
Note:
If transmitter does not operate correctly,
see
Troubleshooting Guide
.
4. Mount Transmitter.
Screw Mounting:
Attach transmitter back cover to wall using two
short screws (provided). Snap transmitter onto back cover.
tape Mounting:
Apply large piece of foam tape (provided)
to the transmitter back cover. Stick transmitter back cover to
frame of door or window in desired position. Snap transmitter
onto back cover.
5. Repeat step 4 to attach magnet to door or window.
