Page 16 of 24
803341NZ - HydroTap Taps Install Instructions 09.18 v2.11
4.5
Installation Instructions - Classic All-In-One Tap
FIXING NUT
CLAMP BLOCK
O-RING
BLUE
to Chiller
connection
CLEAR
to vent
RED
to Boiling
connection
From Mixer
OUT
RED
to Boiling
connection
BLUE
to Chiller
connection
Mains IN
From HWS
connection
Mains IN
To Mixer
IN
R
R
C
B
B
Vented
Mains
Assembled Clamp Block
Note:
If the flow rate is too fast, a teflon flow restrictor is provided
with the tap.
•
Cut the red silicon tube 75mm (minimum) from the bottom of
the base of the All-In-One tap.
•
Insert the Teflon Restrictor about 20mm into the upper seg-
ment of the red silicon tube which connects to the tap.
•
Insert the black plastic outlet bush between the two pieces
of red silicon tubes that was cut.
TEFLON FLOW
RESTRICTOR
BLACK PLASTIC
OUTLET BUSH
