Page 14 of 24
803341NZ - HydroTap Taps Install Instructions 09.18 v2.11
4 - Classic All-In-One Tap
4.2
• Fit the O-ring seal to the base of the tap. If mounting
on an uneven surface, apply a light smear of silicone
sealant to the O-ring, to ensure a watertight seal.
•
Pass the USB cable and tubes through the 50mm hole
and position the tap so that it discharges into the sink.
• Thread the cable and silicon tubes through the circular
clamp block (see figures 4.3 & 4.5) and fix with nut.
• Affix the braided hoses (see figures 4.4 & 4.5).
For A-I-O tap:
50mm hole
Double Bowl
4.1
SINK TOP
50mm
Classic All-In-One Tap
Vented or Mains
Position the tap such that it dispenses into the sink
bowl with ample clearance for a cup or tea pot.
Cut a 50mm hole in the bench / sink top.
CLAMP
BLOCK
Braided
hoses
Extension
tubes
Typical Vented assembly
O-ring
