P A G E 1 0
206-3686
Hook Up An Over-The-Air Antenna
Mini glossary
75 OHM RF CABLE
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack (Antenna/Cable). They are usually about an inch long
with two screws on one end and a round opening with a wire sticking out on the other end.
Connect an off-air antenna
If you have a 75 ohm RF cable, then you don’t
need any adapters!
A 300 to 75 ohm adapter is not included with the
Zenith TV.
300 TO 75 OHM
ADAPTER
Typical
TV Back
S-Video In
M.P.I.
R Audio In L
S-Video Out
Antenna
Cable
Component Video Input
R Audio In L
R Audio L
Video In
Y
Pr
Pb
Matrix Out
Flat Wire
(300 ohm)
Antenna
300/75 ohm
Adapter
Typical
TV Back
S-Video In
M.P.I.
R Audio In L
S-Video Out
Antenna
Cable
Component Video Input
R Audio In L
R Audio L
Video In
Y
Pr
Pb
Matrix Out
RF Coaxial Wire
(75 ohm)
Antenna
Locate the Antenna/Cable jack on the back of
the TV.
Connect the antenna that runs from the wall
directly to this jack, according to one of the
connection diagrams shown to the right.
Remove the back of the remote and put in two
AA batteries.
Plug in your TV. This TV is designed to operate
on standard current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC Current.
Back of
Remote
120 Volt
60 Hz AC
1
2
3
4
