P A G E 1 1
206-3686
Hook Up Cable Service (CATV)
If you’re using a cable box, tune the TV to
channel 3 or 4 and use your cable box to
change channels.
If you’re using a cable box, Auto Program might
only find the channel your cable service is on
(usually channel 3 or 4). Don’t worry, that’s all
you need!
Typical
TV Back
S-Video In
M.P.I.
R Audio In L
S-Video Out
Antenna
Cable
Component Video Input
R Audio In L
R Audio L
Video In
Y
Pr
Pb
Matrix Out
Cable TV
Wall Jack
RF Coaxial Wire
(75 ohm)
Typical
TV Back
S-Video In
M.P.I.
R Audio In L
S-Video Out
Antenna
Cable
Component Video Input
R Audio In L
R Audio L
Video In
Y
Pr
Pb
Matrix Out
Cable TV
Wall Jack
Cable Box
In
Out
RF Coaxial Wire
(75 ohm)
3 4
output
switch
Locate the Antenna/Cable jack on the
back of the TV.
Connect the CATV cable that runs from the
wall according to one of the connection
diagrams shown to the right.
Remove the back of the remote and install
two AA batteries.
Plug in the TV. The TV is designed to
operate on standard current, 120-volt 60
Hertz AC. Do not attempt to operate it on
DC Current.
120 Volt
60 Hz AC
1
2
3
4
Connect cable service to the TV
Back of
Remote
