STOL
CH750
Zenith Aircraft Company
www.zenithair.com
Rear Fuselage Top Skin & Rear Fuselage
Assembly
Section 75-FA-2Page 9 of 9
Revision 2.0 (8/13/2010)
© 2010 Zenith Aircraft Co.
With a hacksaw, trim the Longerons flush with the aft edge of the Bottom Skin and the Side Skins. Cleco the
Middle Rudder Hinge Plate, Rudder Hinge Shim, and Lower Rudder Hinge Plate to the Bottom Skin. The
Rudder Hinge Shim is positioned between the Longerons and flush with the aft edge of the Bottom Skin. Use
a #30 drill bit to expand the holes, then expand the holes with a #20 drill bit and Cleco. Expand the center
hole to 5/16” for the Tie Down Ring.
Cleco the Upper Rudder Hinge Plate to the Top Skin (not shown) and Longerons.
Expand the holes to 3/16”.
P/N:
75F2-7
Upper Rudder Hinge
Plate