Zenitel RCS01, Product Manual, Page: 15 / 24

RCS01 - Product Manual
4 Maintenance
There are no routine maintenance tasks for the Charging Station, except for mains supply fuse replacement
when required, and occasional removal of any dust or debris, which may have fallen into the charging bay.
4.1 Replacing the Mains Power Supply Fuse
Please read and observe the “ Safety and Precautions ” section on page 21 of this manual.
!
!
FUSE DRAWER
2 x T 1A L 250V
1.
Ensure that the power switch on the Charging Station is switched off.
2.
Disconnect the power supply cable.
3.
Pull out the fuse drawer, located with the IEC inlet at the left side of the Charging Station.
4.
Check that the fuses are intact, and then replace them if required.
Replace with type T 1A L 250V.
Issue: 03 complete, approved
Page 15 of 24