Zener SMARTSTART 6000, Instruction Manual

Page: 28 / 57

Programming
Technical Manual: Smartstart
®
6000 IMI0042 rev K
Page 25
P33 Curr Imbal Delay:
Set a delay for the current imbalance trip.
Range: 0 – 10 seconds
Default: 10s
To save changes
To exit without saving
P40 Undercurrent:
To enter submenu to modify
To exit sub menu
P41 Undercurrent Alarm:
Protection against under current. This protection is
not active during accel & decel period. Active when
motor is up to speed.
Range: off; trip; warn
Default: off
To save changes
To exit without saving
Ideal for detecting loss of load or low load conditions
such as belt breakages or blocked water pipes.
‘Trip’: The soft starter trips , stops the motor and indicates
an ‘undercurrent trip’. The Trip relay will change state if
selected.
‘Warn’: The soft starter does not trip or stop the motor. See
D05 & D06 for more information regarding warning alarms.
P42 Undercurrent Level:
Adjust to the desired trip threshold, as a percentage
(%) of the Motor Amps.
Range: 10 – 100%
Default: 10%
To save changes
To exit without saving
P43 Undercurrent Delay:
Adjust to set the time period that the current must
fall below the threshold before a trip occurs.
Range: 1 ‐ 90 seconds
Default: 10 s
To save changes
To exit without saving
P50 Overcurrent:
To enter submenu to modify
To exit sub menu
P51 Overcurrent Alarm:
Provide protection against over current. This
protection is not active during the accel & decel
period.
Range: off; trip; warn
Default: off
To save changes
To exit without saving
‘Trip’: The soft starter trips, stops the motor and indicates
an ‘over current trip’. The Trip relay will change state if
selected.
‘Warn’: The soft starter does not trip or stop the motor. See
D05 & D06 for more information regarding warning alarms.
P52 Overcurrent Level:
Adjust to the desired trip threshold, as a percentage
(%) of the Motor Amps.
Range: 80 – 250%
Default: 100%
To save changes
To exit without saving
P53 Overcurrent Delay:
Adjust to set the time period that the current must
exceed the threshold before a trip occurs.
Range: 0 ‐ 30 seconds
Default: 10 s
To save changes
To exit without saving
P60 Under Torque:
To enter submenu to modify
To exit sub menu
Status
Level
Delay
P40 Undercurrent
Trip 5%
5s
Status
Level
Delay
P50 Overcurrent
Trip 110% 2s
Status
Level
Delay
P60 Under Torque
Trip 10% 10s