58
AH1500-001_v01
4
The basis of the humidifier turn so that the side with the
control panel was lying on the ground.
5
Press the catch located in the filter cover and pull the
inlet filter from the base of air humidifier.
Rinse the filter under running water. Before
re-assembling be sure to dry the filter.
6
Place the inlet filter in the previously occupied space,
attach the filter cover and press it down firmly.
Turn the humidifier’s base to the natural position. Place the
water tank by putting it on the base of the humidifier. Mount
the steam jet on the water tank. Water begins to overflow to
the base of the humidifier.
Troubleshooting
Check the below listed comments and notices before requesting service.
PROBLEM
POSSIBLE CAUSE
REMEDY
The display and operation indicators are not
working, no haze and air blow.
The appliance is not plugged into a wall
outlet.
Plug the cord into an electrical outlet.
No power to the appliance.
Check electric circuit – fuses.
The appliance is on, no haze and air blow.
The water level in the tank for water has
fallen below the required.
Fill the water tank.
Too low humidification level is set.
Check electric circuit – fuses.
Too much water in the base of humidifier.
Fill the water tank.
Float switch is jammed.
Remove the water tank from the base and
unlock the float switch.
If the indoor humidity level is higher than
85% RH, it will stop producing steam and
the display shows “H% RH”.
When the level of humidity in the room
drops to 60% RH the appliance resumes
production of steam.
The appliance emits an unpleasant odor.
The new appliance.
When you turn on and use the appliance for
the first time, there may be present a specific
odor. This is not a threat, or does not indicate
a malfunction of the appliance. The smell
should cease after repeated use.
Remove the water tank from the base of the
humidifier and leave an open tank for at least
12 hours.
The water in the tank water is not clean or
has not been changed for a long time.
Clean the water tank and humidifier base,
fill with clean water.
Humidifier does not produce enough steam.
The ultrasonic transducer was covered with
deposited scale.
Clean the ultrasonic transducer.
The water in the tank water is not clean or
has not been changed for a long time.
Clean the water tank and humidifier base,
fill with clean water.
Strange noises during appliance operation.
A resonance resulting from low water level in
the water tank.
Fill the water tank.
The appliance is located on an unstable
surface.
Place the appliance on a stable, flat surface.
A mist comes out around the jet.
The gap between the jet and container.
Soak the jet in the water for a while, and
then mount it on the appliance.
Summary of Contents for AH1500
