5
Getting Started
Unboxing the ZEISS UVClean
Carefully remove the ZEISS UVClean from the box and place
on a secure surface. (Figure 1) Locate and remove power
cord, box with UVC bulbs, Bulb End Caps, and gloves from
the packaging. Retain all packaging materials for future use.
Installing UVC bulbs and end caps
Prior to installing a UVC bulb, please add a Bulb End Cap
to both ends of the bulb. (Figure 2) The round part should
face toward the middle of the bulb. Be sure to do this while
wearing the provided gloves. Please note that the Lid Bulb
End Caps should be used together on the bulb for the lid.
Open the ZEISS UVClean lid and locate the four bulb
mounts inside the device. One bulb is located in the top lid
and the remaining three are positioned on the sides and
in the middle of the bottom chamber. (Figure 3) Wearing
the provided gloves, align the two end pins with the slots
on the bulb mounts. (Figure 4) Push the pins fully into the
spring-load mounts and twist the bulb ¼ turn. The pins will
click into place. Repeat for the remaining three bulbs. After
installing the bulbs, slide each cap outward toward the wall
of the chamber. (Figure 5) Install all four bulbs at the same
time and prior to proceeding to the next step.
About the ZEISS UVClean
ZEISS UVClean Diagram
Lid
UVC bulbs (4)
Cycle start button
LED indicator light
Frame holder rails (2)
Power switch
Cleanout tray
Air intake
1
2
3
4
5
1
6
11
11
10
10
7
8
9
7
12
12
2-5
8-9
6
Figure 1
Figure 5
Figure 2
Figure 3
Figure 4
CAUTION:
Always use extreme caution when handling
UVC bulbs. Only hold the bulb by the white end caps
and not the glass tube. Only handle new bulbs while
wearing gloves. Failure to follow these instructions may
cause bodily injury.
