ZEISS
Notes on Instrument Safety
Primovert
6
415510-7244-001
12/2014
1.3
Unpacking, Setup, Transportation, Storage
Please observe the following safety notes for unpacking, transportation and storage of the microscope:
−
The microscope is supplied packed to commercial standards in a plastic case with outer cardboard
package; use the original packaging for transportation.
−
Retain the original packaging for a longer storage of the microscope or its return to the manufacturer.
−
When unpacking the equipment, check all components for completeness according to the delivery
note.
−
Keep transport and storage temperatures as specified in the Technical Data.
−
Set up the microscope on a stable worktable with solid and smooth tabletop.
While using the microscope and up to about 10 minutes after the use there is risk of burns due
to the hot lamp housing.
1.4
Disposal
Please observe the following safety notes for disposing of the microscope:
Defective microscopes should not be disposed of with household waste; dispose of them in
compliance with the provisions of the law.
The manufacturer of the device is under the legal obligation to take back defective devices.
1.5
Operation
The microscope including its original accessories must not be used for microscopic techniques other than
those described in this operating manual.
Please observe the following safety notes when using the microscope:
The manufacturer cannot assume any liability for other applications, including those of
individual modules or single components. This also applies to any service or repair work that is
not carried out by authorized service personnel. In case of non-compliance, all warranty claims
shall be forfeited.
Do not operate the devices and their accessories included in the delivery in potentially explosive
areas nor in the presence of volatile anesthetics or combustible solvents, such as alcohol,
benzine or similar chemicals.
Dirt and dust may impair the performance of the devices. The devices must therefore be
protected from such influences to the greatest possible extent and covered with the dust cover
when not in use. Before covering the devices always check whether they have been switched
off or have switched off themselves automatically in AUTO-OFF mode (then, the blue power-
on LEDs on the right and left side of the stand are off).
