Zeiss OPMI PROergo S7, Instructions For Use Manual

Page: 82 / 268

Device overview S7 / OPMI PROergo
Version 11.0
Page 82 G-30-1435-en
Connector panel of S7 floor stand
1 Opening for system cable of external video camera
2 Remote connection
For controlling external devices (e.g. MEDIALINK 100) with a maximum
switching capacity of 24 V / 0.5 A.
3 Potential equalization pin
This connector can be used to connect other active devices to the same
ground potential or for redundant connection to the protective ground.
4 connection strip for switching element (option)
Connection option for a foot control panel
5 Power output socket
For medical devices with power consumption of 115 V~ with a maximum
of 400 VA and for 230 V~ with a maximum of 800 VA.
The current of this power output socket can not be switched off with the
power switch.
6 Power input socket
7 Strain relief
The strain relief prevents inadvertent disconnection of the following
electrical connections:
– power cord,
– video connection cable,
– connection cable for the foot control panel (optional).
8 BNC video port (option)
For VBS video signal output.
9 Y/C video port (option)
For S-VHS video signal output.
CAUTION Risk of electric shock caused by unapproved or defective accessories!
Unapproved or defective accessories can cause increased leakage current!
• When setting up your system, be sure to comply with the requirements
of IEC 60601-1, section 16 (in some countries IEC 60601-1-1 may still be
valid).
• Comply with the Medical Device Operator Ordinance or other national
laws.