Zeiss OPMI Pentero, Brief Instructions

Page: 6 / 40

6
G-30-1702-en OPMI® Pentero® Software Release 2.2 Issue 2.0
Printed on 17. 03. 2008
Positioning the system at the operating table
The stand is provided with a handle which allows the reliable and easy
guidance of the system during relocation. Please only use this handle for
this purpose.
The stand base is equipped with the new FlexiTrak technology which
makes it considerably easier for you to move and position the system in
the OR. Two additional pedals on the base allow you to conveniently se-
lect the required condition of the stand:
– None of the pedals has been pressed:
Exact and sensitive positioning in the OR and at the operating table in
all directions with a minimum of effort.
– Right-hand pedal (2) is pressed down hard until it snaps in:
Reliable and precise straight-ahead movement, also over low thresh-
olds (elevator). Press this pedal until it snaps in to set the two front
casters for straight-ahead travel. The other casters remain steerable.
When you slightly press pedal (1), all four casters will be steerable
again.
– Pressing left-hand pedal (1) to the stop will lock the stand base in po-
sition, preventing it from inadvertently rolling away. After the system
has been finally positioned at the operating table, you should step on
this pedal.
3 Possible positions for cranial procedures
4 Possible positions for face-to-face procedures (spine)
5 Surgeon
6 Assistant
Note:
The system allows overhead positioning and can therefore be placed in
any position behind the surgeon or assistant.
1 2