31
The temperature sensor is located inside the room thermostat unit. Therefore,
the room thermostat should be:
_ mounted on a wall or placed on a shelf or an accessible piece of furniture at a
height of approximately 1.50 m
_ protected from sources of heat (light, sunlight, etc.) and draughts (windows,
doors, fans)
_ and should not be placed on an exterior wall or a wall adjoining an unheated
room (garage etc.).
The thermostat can either be stood on
the stand supplied or mounted on a
wall.
2.1.1 wall mounting
Remove the cover using a screwdriver
(
A
). Remove the batteries supplied
with the device.
Secure the thermostat to the wall
using screws and wall plugs or place in
an electrical mounting box (
B
: centre
to centre distance 60 mm).
Replace the batteries,
ensuring the correct polarity.
2.1.2 Using the stand
You can place the transmitter on a piece of
furniture using the stand supplied.
A
B
1
2
+
-
-
+
Wall mounted
Approximate
height
1.50 m
20 cm min
On a piece of
furniture
E N
2 The IR Prog room
thermostat
CAUTION
Your radiator is not compatible with any control unit other than the
room thermostat supplied.
2.1 Positioning the room thermostat
For effective control of your appliance, the thermostat must be able to measure
the most representative ambient temperature in your room.
To ensure that the infrared signal is correctly received, the thermostat must be
located in the same room as your towel radiator and be no more than 10 m away
from the radiator in direct line of sight uninterrupted by any obstacle (wall,
furniture, etc.).
Under certain conditions, the signal can be reflected off smooth shiny surfaces
(such as tiles).
Before installing the thermostat permanently, check for objects likely to disrupt
signals between the transmitter and the receiver on the towel radiator, and carry
out an infrared signal test (see section 4.3).
Low battery indicator symbol
Time
Temperature (setpoint
or room temperature)
Selection buttons
Automatic mode
Economy
Frost Protection
No Heat
Current mode (e.g. Comfort)
Current day
Heat command active
Program profile
Comfort
Set time
Program
Cover opening point
30
E N
