8
SHADING REMOVAL
If you need to remove your shading, follow the instructions
below.
Partially lower the shading and insert a flat head screwdriver as
shown.
Twist the screwdriver until the head rail disengages from the
bracket.
As you release the brackets, support the head rail to keep it
from falling.
CLEANING AND CARE
The shading fabric is easy to care for. Regular dusting with a feather duster or vacuum cleaner brush is recommended.
Most stains can be blotted with a damp sponge and mild detergent. Before using anything stronger than mild detergent
and lukewarm water, test an unobtrusive corner of the shading. If you have any questions, call your dealer for advice.
TROUBLE SHOOTING
PROBLEM
SOLUTION
The motor does not work
1. Check that the power source and motor are connected
properly
2. If using a battery wand - confirm that the batteries are
fresh and are placed in the wand in the correct orientation.
The motor continues to run in one direction
The limit setting was unsuccessful and needs to be reset
The indicator light on the remote does not shine or the
remote-controlling range becomes shorter
Replace the battery in the remote (CR2430 lithium)
The motor stops working or works intermittently
If using a battery wand, replace the batteries in the wand
with 8 fresh AA alkaline batteries
REPLACING THE BATTERY IN THE REMOTE
Remove the battery tray from the remote by inserting a finger-
nail into the indentation on the back of the remote. To avoid
the battery falling out of the remote, remove the tray while the
remote is face up.
Insert the new battery (CR2430 lithium) into the battery tray so
that the writing is facing up when the remote is face up. Slide
the tray back into the remote.
Insert fingernail here
LITHIUM BATTERY
CR2430 3V
