ZebraBlinds Crown Premium, Installation & Care Instructions

Page: 6 / 9

5
ADJUST MOTOR LIMITS ON PRIMARY REMOTE (IF DESIRED)
A. Set Lower Limit
B. Set Upper Limit
1 2 3 4 5
Channel
Display
Up
Stop
Down
C
Channel -
C
L
Confirm
Limit
OPERATION RESULT
1
Hold
LIMIT
button down The motor begins to jog
2
Release the button after jogging stops The motor is ready for limit setting
3 Press
DOWN
button The motor will go down continuously
4 When the motor is close to the desired
lower limit, press
STOP
button on the
remote
The motor stops running
5
Press either the
UP
or
DOWN
button The motor runs step by step to adjust lower
limit accurately
6 Confirm the setting by pressing the
CONFIRM button on the remote
The motor jogs and the lower setting is
completed
OPERATION RESULT
1 Press UP button on the remote
transmitter
The motor will go up continuously
2 When the motor is close to the desired
upper limit, press
STOP
button on the
remote
The motor stops running
3
Press either the
UP
or
DOWN
button The motor runs step by step to adjust upper
limit accurately
4
Confirm the setting by pressing the
CONFIRM button on the remote
The motor jogs and the upper setting is
completed
The lower and upper limits have been set at
the factory. If you need to make adjustments
to the limits, follow the instructions below.
Please Note: When clearing the factory set
limits, both the upper and lower limits will
need to be reset.
Use the CHANNEL buttons to select the
channel for the shading that needs to be
adjusted. Then follow the directions below.
If only adjusting one shading on a channel,
unplug the other shadings.
CHANGE FAVORITE POSITION (IF ONE WAS SET)
Use the
UP
or
DOWN
buttons to position the shade at the desired “favorite” position. First press and hold the
LIMIT
button on the back of the remote with a small screwdriver or tip of a pen. While holding the LIMIT button press and hold
the UP button. Release both buttons when the shade jogs.
To erase the “favorite” position bring the shade to the upper limit.
Press and hold the
LIMIT
button on the back of
the remote, then press and hold the
UP
button. Release both buttons when the shade jogs.