4
OPERATION
TRANSFORMER (OPTIONAL)
Plug the transformer wire into the motor wire. Secure the wire behind
the shading and along the window casing as required.
Plug the transformer into an electrical outlet.
If the wire is not long enough to reach, optional 48” extension wires are
available.
BATTERY WAND
Plug the battery wand wire into the motor wire.
STEP 4: CONNECT POWER SOURCE - BATTERY WAND/TRANSFORMER
The factory has set your shading to the channel that was specified at the
time of order. If no channel was specified, the shading was set to operate
on channel 1 and “all”.
Select the desired channel with the
CHANNEL
buttons. The channel
indicator light will illuminate the channel that is on. If all 5 lights are lit
the remote will control all 5 channels at once.
Tapping the
UP
or
DOWN
buttons for less than 2 seconds will move the
shading in short steps. Holding the
UP
or
DOWN
buttons down for
more than 2 seconds before releasing will operate the shading in the faster
standard speed.
Press the
UP
or
DOWN
buttons to raise or lower the shading.
Press the
STOP
button to stop the shading anywhere along the length of
the shading.
To open/close the vanes - lower the shading all the way down. Tap the up/
down buttons to open/close the vanes.
1
2
3
4
5
Channel
Display
Up
Stop
Down
C
Channel -
SETTING AND USING A FAVORITE POSITION
Use the
UP
or
DOWN
buttons to position the shade at the desired
“favorite” position. First press and hold the
LIMIT
button on the back
of the remote with a small screwdriver or tip of a pen. While holding the
LIMIT
button press and hold the
UP
button. Release both buttons when
the shade jogs.
With the shade at either the upper or lower limit, simply press the
STOP
button to bring the shade to the “favorite” position. To go to the “favorite”
position from any other location, make sure the shade has been stopped
for at least three seconds before pressing the
STOP
button.
C
L
Confirm
Limit