Zebex Z-608, User Manual

Page: 11 / 25

Dual-Laser Omnidirectional Vertical Scanner 7
U
SER
’
S
M
ANUAL
2. Insert the 8-pin modular plug of the power link cable into the “host” connector in
the back of the scanner until a firm click is heard.
3. Insert the auxiliary cable connector into the 10-pin “aux” jack until it clicks and
route the cable through the space above the scanner interface cable.
4. Move the scanner into position on the mounting plate, engaging the tab on the
underside. Be careful not to pinch any cables.
5. Replace the mounting plate screws.
Back Mounting
If desired the scanner may be mounted to your own custom bracket using the
threaded mounting holes on the back. (See page 2 Figure) The mounting holes are
threaded to accommodate M4 x 0.7 machine screws to a depth of 5.0 mm.
Make sure your bracket design allows for the exit of the interface cable. The supplied
mounting plate protects the interface cable connection, but requires that the cable
exits from the back of the unit.
Connecting to the Host
The power link interface cable comes with different host-end connectors, depending
on the host. Follow the steps below to connect the interface cable to the host.
1. Make sure that the power of the host system is off.
2. Connect the host end of the interface cable to the appropriate connector on the
host system.
3. For those cases where external power is used, plug the external AC power
adapter into the jack on the interface cable. (See page 2 Figure)
4. Turn on the host system.