Zebex Z-608, User Manual, Page: 8 / 25

Dual-Laser Omnidirectional Vertical Scanner 4
U
SER
’
S
M
ANUAL
2. Insert the 8-pin modular plug of the power link cable into the “host” connector
in the back of the scanner until a firm click is heard.
3. Plug the power adapter into the jack on the power link cable. (See page 2
Figure)
4. Plug the AC end of the power adapter into an AC outlet. The scanner powers
up, the buzzer sounds four beeps and the LED indicator glows blue.
5. Present a known-good test barcode to the scanner. The scanner should issue a
short beep and the LED should flash red momentarily. [If the scan- ner is
connected to a keyboard wedge for this test, it should read one bar- code,
beep, then remain with a red LED indicating light. This is normal when the
keyboard wedge is not connected to a live host terminal.]
Note:
If the scanner does not produce any beeps, or produces the wrong beeps, or
the LED does not light, remove the power connection and refer to the section on
Troubleshooting.
Mounting
After the scanner passes its verification test (section above), proceed with mounting.
The scanner should be installed in a location away from direct sunlight; high levels of
ambient light reduce scanner effectiveness.
The two basic styles of mounting are a) with the included mounting plate, and b) with
a custom bracket (not included) for back mounting. If an auxiliary hand- held scanner
is to be attached, it must be properly connected as part of the mounting process.