Zebex Z-608, User Manual, Page: 3 / 25

Dual-Laser Omnidirectional Vertical Scanner ii
Laser Safety
The Miniature Dual-Laser Omnidirectional Hands-free Scanner complies with safety standard IEC
60825 for a Class I laser product. It also complies with CDRH as applicable to a Class IIa laser
product. Avoid long term staring into direct laser light.
Radiant Energy : The Miniature Dual-Laser Omnidirectional Hands-free Scanner uses two low-power
visible laser diodes operating at 650nm in an opto-mechanical scanner resulting in less than 3.9μW
radiated power as observed through a 7mm aperture and averaged over 10 seconds.
Do not attempt to remove the protective housing of the scanner, as unscanned laser light with a
peak output up to 0.8mW would be accessible inside.
Laser Light Viewing : The scan window is the only aperture through which laser light may be
observed from this product. A failure of the scanner motor, while the laser diode continues to emit
a laser beam, may cause emission levels to exceed those for safe operation. The scanner has
safeguards to prevent this occurrence. If, however, a stationary laser beam is emitted, the failing
scanner should be disconnected from its power source immediately.
Adjustments : Do not attempt any adjustments or alteration of this product. Do not remove the
protective housing of the scanner. There are no user-serviceable parts inside.
Caution : Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous laser light exposure.
Optical : The use of optical instruments with this product will increase the eye hazard. Optical
instruments include binoculars, magnifying glasses, and microscopes but do not include normal eye
glasses worn by the user.
For CE-Countries
This scanner is in conformity with CE standards. Please note that an approved, CE-marked power
supply unit should be used in order to maintain CE conformance.