47
48
Change the channel distribute
Press the SELECT and DOWN keys simultaneously and turn the transmitter on.
Press the UP key until CHNO ASSGIN appears on screen.
Press the SELECT key to select channel that you wish to output signal.
Press the INCREASE or DECREASE key to change the signal out putted by channel.
Press the CLEAR key restoring default values.
◆
Input Select
The Input Select function is used to select the switch input for the gyro gain and the
channel that will operate.
To Select the Function for the AUX2 Channel
Press the DOWN and SELECT keys simultaneously, then turn on the transmitter.
Press the UP or DOWN key until the INPUT SELECT function appears on screen.
Press the SELECT key until AUX2 is highlighted.
Press the INCREASE or DECREASE key to select the desired function.
◇
To Select the Function for the Gear Channel
Press the DOWN and SELECT keys simultaneously, then turn on the transmitter.
Press the UP or DOWN key until INPUT SELECT appears on screen.
Press the SELECT key until GEAR is highlighted.
Press the INCREASE or DECREASE key to select the desired function.
The gear channel options are:
INH:
Inhibit is selected if the gyro function will not be used on the gear channel.
Selecting inhibit turns off the channel, allowing it to be used as a slave channel fo
mixing.
INCREASE
and
DECREASE
key
Press
to
enter
INPUT
SELECT
Hold
while
turning
on
transmitter
[
IN
P
UT
SELECT
]
AUX2
GEAR
GYRO
INH
INCREASE
and
DECREASE
key
Press
to
enter
INPUT
SELECT
Hold
while
turning
on
transmitter
[
IN
P
UT
SELECT
]
AUX2
GEAR
INH
INH
Press
to
reset
[
SKMODE
SELECT
]
MODE
1
ELEV
RUDD
THRO
AILE
Change Pole mode
Press the DOWN and SELECT keys simultaneously, the turn the transmitter on.
Press the UP key until SKMODE SELECT appear on green.
Press the INCREASE and DECREASE keys to change the pole mode.
The T7AH-2400 can assign 7 channels to output in any channel, you can choose a
different style of the channel allocation, can also customize the output channel
allocation output.
[
CHNO
ASSGIN
]
1
:
THRO
2
:
AILE
3
:
ELEV
4
:
RUDD
5
:
GEAR
6
:
FLAP
7
;
AUX2
The Auxiliary 2 channel options are:
INH:
Inhibit is selected if the gyro function will not be used on the Aux 2 channel.
F.MODE:
In this mode, the AUX2 channel is controlled by the flight mode switch and three
positions are available. Sub trim and travel adjust is used to set the center and
end points for each switch position.
AUX2:
The Auxiliary 2 switch controls the AUX2 Channel.
GYRO:
The gyro mode is selected if you want to use the Gyro Sensing (see page 96) for
more detail. Selecting GYRO under AUX2 assigns the gyro sensing program to
operate use the AUX2 channel. In this case the gyro gain must be plugged into the
AUX2 (Channel 7) channel.
