zBoost
®
Max ZB545M Manual
4
Before installing, please note the following important factors in determining your zBoost
performance:
•
At least 15 vertical feet is needed between the External Antenna (receives the outside signal)
and the Indoor Antenna (rebroadcasts the signal indoors). Separation less than 15 vertical feet
will result in decreased performance. See illustration below.
•
Keep the External Antenna at least 3 feet above any metal.
See page 5, Setting Up Your zBoost Product, for additional information.
Additional Cable Requirements
RG-6 cable is used to connect the External Antenna and the Base Unit. Should you need additional
cable length, 15 foot extensions (Part #:
YX030-15w
) are available at www.zBoost.com.
The total cable length should not exceed 65 feet unless you also purchase an upgraded signal
antenna (see page v). A longer cable is helpful only if it allows you to place the External
Antenna in a location where you measure stronger signal.
Grounding the External Antenna
If you decide to place the External Antenna outdoors, it must be properly grounded. (See page
v for a recommended grounding kit).
The set up must be in accordance with Article 810 of the National Electric Code (NEC). A listed
antenna discharge unit must be provided for the lead-in coaxial cable per NEC article 8.10.20 or the
shield of the coaxial cable must be permanently and effectively grounded in accordance with NEC
article 8.10.21. Please consult a professional installer or electrician for more information.
Warning
Avoid placing the External Antenna near metal such as
wiring, A/C ducts, metal siding, truss plates, etc.
When connecting the cable to the antenna, run the
cable straight down from the antenna. Avoid draping
the coax near the antenna.
Maximum Performance
Minimum Performance
15’ of vertical
separation
15’ of vertical
separation
15’ of vertical
separation
Summary of Contents for Max ZB545M
Page 2: ......
