Operation manual of ZBL-R800, ZBL-R630, ZBL-C310A
Hotline: (86)010-51290405 Fax: (86)010-51290406
68
2.
According to requirement, pressing
【
ENTER
】
to shift
measuring direction.
3.
To place electrode on measuring points and observe potential
value display. When the value is stable, pressing
【
SAVE
】
to
store potential in this point and the cursor enters into next
measuring position automatically.
4.
To repeat the third step, until the end of measuring points in
the row (or column).
5.
To press directional key to adjust cursor to display position of
next measuring points and repeat the third and forth steps.
6.
To repeat third, forth and fifth steps until the end of test for the
whole survey area.
7.
When the test is completed, screw down bottom bracket of
electrode and place it in instrument cabinets alone. Then clean
ceramic pieces under the bottom with dry cloth and dry it.
Finally, put on black rubber sleeve in bottom and place it in
the cabinet for next usage. Clean sponge of bottom bracket
with water and place into instrument cabinet directly.
4.2.3 Data check
Please refer to chapter 3.5.4 for specific operation.
4.2.4 Data transmission
After finishing the test, transmit the testing data into U-disk, then into
computer for analysis by software. Please see chapter 3.2 for specific
operation.
