Operation manual of ZBL-R800, ZBL-R630, ZBL-C310A
Hotline: (86)010-51290405 Fax: (86)010-51290406
32
Firstly, connecting the host and the sensor with signal wire, then
pressing
【
a
】
and
【
b
】
keys in main menu interface as shown in
figure 3-6, shifting
to “Grid-scan” and pressing
【
ENTER
】
for
scanning, parameter setting interface will be presented in figure3-13
and parameter can be set.
Then, detector firstly test the quantity of electricity (please see test
of quantity of electricity in “General-scan”).
Figure 3-13 Parameter setting of grid-scan
3.4.2.1 Parameter setting
The default values of all parameters are the set ones of previous
stored object. The setting method is the same with 3.4.1.1.
pressing
【
a
】
and
【
b
】
keys to shift
to options for setting,
and pressing
【
ENTER
】
for selection, pressing
【
a
】
and
【
b
】
keys for modification and shifting and finally pressing
【
SAVE
】
to
store the set value and exit from it.
1)
Dia. X
—the diameter of awaiting measuring rebar in X
direction and the setting range is 6
～
50mm, the default value
is the set one of previous stored object.
2)
Dia. Y
—the diameter of awaiting measuring rebar in Y
direction and the setting range is 6
～
50mm.
3)
Cover X
—the thickness of cover of awaiting measuring rebar
in X direction and the setting range is 10
～
99mm.
4)
Cover Y
— the thickness of cover of awaiting measuring rebar
