ZBL-R630A Rebar Detector
+52 5586114372
+52 7791340470
Fourth step, based on the rebar location after first scan (scanning in X and Y direction in the second step), scanning the
central position between second and third rebar in Y direction for a second time (b2 measuring line in figure 3-24),
pressing
【
SAVE
】
to scan, there will be cursor in the interface. The second scanning is same as the first just as shown in
figure 3-22.
Attention:
1)
In second scanning, it still displays rebar distribution in X and Y direction after first scan, however, it does not
display the coordinates (position and thickness of cover) of each rebar.
2)
In the second scan, it only displays coordinate of rebar but not draws while scanning over rebar.
3)
Fifth step, when scan distance go over the distance displayed by one screen, the instrument turn to the second
screen, as shown in figure3-23, zero point of coordinate in the upper left will increase one correspondingly. Users
can continue scanning in this interface, The maximum distance can not be more than the maximal distance in the
first scan of this direction in second step.
Figure 3-23 Second scanning in X direction
Figure 3-24 Second scanning in X direction
Sixth step, after scanning between the second and third rebar in Y direction, pressing
【
SAVE
】
key to end this
scanning.
Seventh step, similarly, scans for a second time in the central position between the tested third and fourth rebar in
Y direction (such as measuring line b3 shown in figure 3-24) and so on.