ZBA BC04-191, Manual

Page: 21 / 25

Command Response Parameter
AT+LADDR? OK
LADDR<Para1>
Para1
Device address
8.2.19 Set/Inquired Paired Device Address
ZBA,
Inc.
Command Response Parameter
AT+RADDR=<Para1> OK
AT+ RADDR? OK
RADDR<Para1>
Para1 Paired device
address
Example to set-up the Module to communicate with one specific BT device whose BT
address is currently unknown.
First type:
AT+INQ?
What is returned are the BT addresses of the devices in the BT neighbourhood.
Then type
AT+RADDR= BT address
(the specific device you wish to pair determined from the
AT+INQ? Command).
The module will remain bound to this address until the
AT+CLEARADDR
is run or the
module is powered off and then back on again.
8.2.20 Inquired Device BD Address
Note: This command returns the (local) BT address of the module.
8.2.21 Software Reset
Command Response Parameter
AT+ RESTART OK None
8.2.22 Set/Inquire about Low power mode
Command Response Parameter
AT+LOWPOWER=<Para1> OK
<Para1> ：
0
：
low power disabled
1
：
Low power mode Enabled
AT+ LOWPOWER? OK
+LOWPOWER
： <Para1>