Chapter 2
_____________________________________________________
Zaxcom Nomad User’s Manual
52
Output Levels page
Page purpose:
This page manages the audio levels for the specified outputs.
How to get here:
(
MENU
knob
once
ENG Setup
button
Output Levels
button
)
Figure 2-58 Output Levels page
TA-5 & XLR-3 Output Bus Levels
Each of the 6 main output busses can be independently selected to one of the following output levels: 0dBu (line
level), -10dBu (tape / consumer level), -35dBu (mic level). For example, output bus 1 can feed the XLR #1 out at
0dBu and the TA5 #1 at -35 at the same time.
Mono & Tape Output Bus Levels
These outputs are continuously adjustable in 1 dB steps from -12dBu to +21dBu.
Advanced Setup page
Page purpose:
This page is for changing aspects of the machine that most people will not need to do.
How to get here:
(
MENU
knob
once
ENG Setup
button
Advanced Setup
button
)
Figure 2-59 Advanced Setup page
PREVENT EMPTY PAN
button
– Set to
ON
, removes the blank option while in ENG mode, leaving only
L
,
C
,
R
.
DISPLAY SPEED
button
– Should always be set to FAST.
NOTE:
Currently the display is updated every frame when possible. When display speed is set to
SLOW
, it
does not try to update quite that fast. This is in case you load up the machine with tons of effects and
crosspoints and/or run at 96 kHz and find that the user interface is getting hard to use. It is just a
precautionary measure.
The display will also automatically slow down when mirroring or when the unit needs more horsepower for
recording a lot of tracks.
