USER AND MAINTENANCE MANUAL
30
ELECTROMAGNETIC VALVE
DLK22LT-LC
6.7
Valve assembly
Before to assembling the valve the following steps must be done:
• Remove the residual glue from the valve using a wet rag or soft brush
• Clean the nozzle and if it is necessary put it under running water then blow it with compressed air
and clean the nozzle hole with the cleaning needle
• Check the wear of the O-rings and if it is necessary replace it
• Before the assembly always grease the O-rings
Then proceed as follows:
Place the coil into the valve body
being careful to the assembly
direction;
Insert the guide sleeve through the
valve body and the coil, then screw it
with a 15mm wrench;
Insert the micrometric adjustment
and with a 13mm wrench screw it
into the valve body;
1
2
3
!
15
13
