Zass ZPAC 09, Operating Instructions Manual

Page: 9 / 28

9
English
5. MAINTENANCE
6. COMMON FAULTS AND TROUBLESHOOTING
5.1. Machine cleaning
Turn off the power supply of the machine and wipe the machine with a soft semi dry rag. Do not use
chemical reagents, such as benzene, alcohol, gasoline, etc. Otherwise, the air conditioning surface will
be damaged, or even the whole machine will be damaged. Do not let water splash into the machine.
6.1. Intelligent Fault Detection
5.4. Seasonal maintenance
If you do not use the machine for a long time, please follow the steps below to maintain it:
• Drain the water from the tank.
• Clean and reinstall the filter screen
• Cover the machine with plastic bags and place it in a cool and dry place.
If it is not used for a long time, please pay attention to the following points when using it again:
• Confirm whether there is water in the water tank or whether the water volume meets the requirements.
There will be a prompt when you start the machine. Please follow the prompt.
• Check whether the power cord is in good condition. Do not use it if it is damaged.
Knob Air inlet grille Filter screen
5.2. Filter screen cleaning
Unscrew the two knobs of water inlet and water outlet from
the rear side, then remove the rear air inlet grille, and remove
the filter screen from the rear air inlet grille for cleaning. Put
the filter screen into clean water or warm water (about 40°C)
which has been added with neutral detergent, and then place
it in dry air to dry naturally, and then reinstall the filter screen.
NOTE: a). Do not use water with too high temperature (suitable
temperature is about 40°C) or irritant detergent (such as
alcohol, gasoline, benzene, etc.) to clean the filter screen;
b). In order to avoid the deformation of the filter screen,
the cleaned filter screen should be kept away from the heat
source and put in the dry air to dry naturally;
c). It is recommended to clean the filter screen once
every two weeks.
5.3. Filter screen cleaning
It is recommended to replace the water in the water tank
through drainage / water inlet at least every quarter.
Fault Code
E1
E2
Code Meaning
Water shortage of water
tank
Please connect the water inlet
pipe and press the
[water inlet] key to feed water
Please connect the drain pipe
and press the [drain] key
to drain
Water tank is full
Solution