Zass ZPAC 09, Operating Instructions Manual

Page: 6 / 28

6
NOTE: a). During cold storage, the wind is at high speed and the swing blade is at the maximum outlet
angle. At this time, the heat energy will be discharged. In a narrow space, please open the doors and
windows for ventilation.
b). The actual temperature of water in the water tank is displayed during cold storage.
c). The air inlet and air outlet shall not be covered.
3.7. Heat Storage
• Press the [mode] key to select the heat storage function
• After the completion of heat storage, it will automatically enter the standby insulation state.
NOTE: a). During the heat is storage, the air outlet fan is closed, and there is no air volume to blow out
at this time.
b). The actual temperature of the water in the tank is displayed during heat storage.
3.8. Heating
• Press the [mode] key to select the heating function
• Press the [+] or [-] key to set the heating temperature, and set the temperature range between 16°C and
32°C
• Press the [wind speed] key to select low wind, high wind and automatic wind speed
• Press the [swing wind] key to select the upper and lower swing blades to swing or stop.
NOTE: a). The actual temperature of the water in the tank is displayed during heating.
b). The air inlet and air outlet shall not be covered.
3.9. Ventilation
• Press the [mode] key to select the ventilation function
• Press the [wind speed] key to select low wind, high wind and automatic wind speed
• Press the [swing wind] key to select the upper and lower swing blades to swing or stop.
NOTE: During ventilation, it displays actual air inlet temperature.
3.10. Preset
Preset Setting:
• Press the [preset] key to enter the preset mode, and then select the cold storage preset and heat storage
preset.
• Press the [preset] key to confirm cold storage preset or heat storage preset.
• Press [+] or [-] to select how many hours to use after the preset, and select the time interval between
6 hours and 24 hours. After selecting the time, press the [preset] key again to confirm, and the voice
prompts that the preset is completed.
Preset cancellation method:
• Press the [preset] key again, the previous preset will be cancelled, and a new preset can be made at
this time
• After the power is off, the preset will be cancelled automatically
• Press and hold the [preset] key for more than 3 seconds to cancel the preset.
NOTE: a). A few hours before the preset, the machine starts cold storage or heat storage. After the end
of cold storage or heat storage, it will automatically enter the standby insulation state.
b). Other operations can be carried out after the preset, and other operation instructions take
precedence over the preset setting. If other operations end before the preset time, the preset will continue.
c). When using preset, please make sure the windows open for ventilation.