Page 17
4 REGULATION
4.1 ZAPI PROGRAMMING HANDLY CONSOLE
In Combi Sem-1 controller is possible to program several functions through the console.
In this way is possible to modify the performances of the truck following the customer
needings.
The console can remain connected to the controller while running and the parameters
can be changed in real time. In this case it is important to go in stand by condition
before switch off the controller in order to give the possibility to store the new values in
the Eeprom.
This section describes the ZAPI console functions.
Six buttons provide the capability of changing or reading the parameter of the Combi:
1
Roll-Up
push to scroll up the submenu and to select a parameter;
2
Roll-Down
push to scroll down the submenu and to select a parameter;
3
Enter
push to have access to the selected submenu or to confirm a
changement;
4
Out
push to exit the selected menu or to refuse a changement;
5
Set-Up
push to increase a parameter;
6
Set-Down
push to decrease a parameter;
Note: After a modify, memoriz the new value pushing the "4" (Out) button and the "3"
(Enter) button. Double pushing of the "4" (Out) button doesn't save the value.
Numbers inside the triangles in the following map correspond to the same number on
the console keyboard buttons shown in the figure below. The orientation of the triangle
indicates the way to the next function.
Important
CONNECT AND DISCONNECT THE CONSOLE ONLY WITH THE CONTROLLER
SWITCHED OFF.
