Zanussi ZWC1301, User Manual

Page: 7 / 28

UNPACKING
1. Open the door. Remove all items from the
drum.
2. Put the packaging element on the floor behind
the appliance and carefully put it down onto its
rear side. Remove the polystyrene protection
from the bottom.
CAUTION! Do not lay washing
machine on its front.
3. Put the appliance back into an upright position.
Remove the power supply cable and the drain
hose from the hose holders.
It is possible to see water flowing
from the drain hose. This is
because the washing machine has
been tested at the factory.
4. Remove the three transit bolts and pull out the
plastic spacers.
We recommend that you keep
the packaging and the transit
bolts for any transport of the
appliance.
5. Put the plastic caps, that you find in the user
manual bag, in the holes.
INFORMATION FOR INSTALLATION
Positioning and levelling
Adjust the appliance correctly to prevent vibration,
noise and movement of the appliance when it
operates.
1. Install the appliance on a flat hard floor. The
appliance must be levelled and stable. Make sure
that the appliance does not touch the wall or other
units and there is air circulation below the
appliance.
2. Loosen or tighten the feet to adjust the level. All
feet must rest firmly on the floor.
WARNING! Do not put cardboard,
wood or equivalent materials below
the appliance feet to adjust the level.
The inlet hose
CAUTION! Make sure there is no
damage to hoses and there are no
leaks from the couplings. Do not use
an extension hose if the inlet hose is
too short. Contact the service centre
for a replacement inlet hose.
1. Connect the water inlet hose to the back of the
appliance.
7