Zanussi ZWC1301, User Manual

Page: 18 / 28

– there is large amounts of foam during
washing.
• When using detergent tabs or pods, always put
them inside the drum, not in the detergent
dispenser.
Insufficient detergent may cause:
• unsatisfactory washing results,
• the wash load to turn grey,
• greasy clothes,
• mould in the appliance.
Excessive detergent may cause:
• sudsing,
• reduced washing effect,
• inadequate rinsing,
• a greater impact for the environment.
ECOLOGICAL HINTS
To save water, energy and to help protect the
environment, we recommend that you follow these
tips:
• Normally soiled laundry may be washed
without prewash in order to save detergent,
water and time (the environment is protected
too!).
• Loading the appliance to the maximum
capacity indicated for each programmes
helps to reduce energy and water
consumption.
• With adequate pre-treatment, stains and limited
soiling can be removed; the laundry can then be
washed at a lower temperature.
• To use the correct quantity of detergent, refer to
the quantity suggested by the detergent
producer and check the water hardness of your
domestic system. Refer to "Water hardness".
• Set the maximum possible spin speed for
the selected washing programme before
drying your laundry in a tumble dryer. This
will save energy during drying!
WATER HARDNESS
If the water hardness in your area is high or
moderate, we recommend that you use a water
softener for washing machines. In areas where the
water hardness is soft it is not necessary to use a
water softener.
To know the water hardness in your area, contact
your local water authority.
Use the correct quantity of the water softener.
Obey the instructions that you find on the
packaging of the product.
CARE AND CLEANING
WARNING! Refer to Safety chapters.
PERIODIC CLEANING SCHEDULE
Periodic cleaning helps to extend the life of
your appliance.
After each cycle, keep the door and the detergent
dispenser slightly ajar to get air circulation and dry
the humidity inside the appliance: this will prevent
mildew and odours.
If the appliance is not used for a long time: close
the water tap and unplug the appliance.
Indicative periodic cleaning schedule:
Descaling Twice a year
Maintenance wash Once a month
Clean door seal Every two months
Clean drum Every two months
Clean detergent dis-
penser
Every two months
Clean the inlet hose
and the valve filter
Twice a year
The following paragraphs explain how you should
clean each part.
REMOVING FOREIGN OBJECTS
Make sure that pockets are empty and
all loose elements are tied up before
running your cycle. Refer to 'The
laundry load' in 'Hints and tips'.
Remove any foreign objects (such as metal clip,
buttons, coins, etc) that you may find in the door
seal, the inlet hose filter and the drum. Refer to
'Door seal with double lip trap', 'Cleaning the drum'
and 'Cleaning the inlet hose and the valve filter'
paragraphs. If necessary, please contact the
Authorised Service Centre.
EXTERNAL CLEANING
Clean the appliance with soap and warm water
only. Fully dry all the surfaces. Do not use a
scouring pads or any scratching material.
18