30
Carefully level by screwing the adjustable feet
in or out. Never place cardboard, wood or simi-
lar materials under the machine to compensate
for any unevenness in the floor. After having
levelled the machine, tighen the lock nuts.
Water inlet
The inlet hose is already hanges on the rear of
the machine.
Do not use the hose from your previous
machine to connect to the water supply.
Attenzione!
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap.
1. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure to
tighten the ring nut again to prevent leaks.
2. Connect the hose to
a tap with a 3/4”
thread. Always use the
hose supplied with the
appliance.
HEC0006
Water drainage
The end of the drain hose can be positioned in
three ways:
Hooked over the
edge of a sink using
the plastic hose
guide supplied with
the machine. In this
case, make sure the
end cannot come
unhooked when the
machine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.
Onto a sink outlet spigot.
If the outlet spigot has not been used before,
remove any blanking plug that may be in
place. Push the drain hose onto the spigot
and secure with a clip. Ensure a loop is
formed in the drain hose (see diagram) to
prevent waste from the sink entering the
washing machine.
Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter
of the drain hose.
Loop
132962620_en.qxd 26/07/2008 12.21 Page 30
