IMPORTANT!
If an option which is not compatible with the set
wash programme is selected, the message Err
is displayed for a few seconds and the red light
of this button flashes for 3 times.
Select the delayed start by pressing the
button
10
Press this button to select the required delay.
The selected delay time value will appear on
the display for a few seconds, then the duration
of the programme will appear again.
You must select this option after you have set
the programme and before you press the
button
8
.
You can cancel the delay time at any moment,
before you press button
8
. If you have already
pressed it, and you wish to
CANCEL
the delay
time, proceed as follows:
• set the washing machine to PAUSE by
pressing button
8
;
• press the button
10
once. On the display will
appear the symbol «
0’
».
• press button
8
again to start the programme.
IMPORTANT!
• The selected delay can be modified only after
you have turned the programme selector dial
to the «
O
» position and after you have
selected the programme again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing button
8.
The door can be opened
immediately or after a few minutes depending
on the model. (In any case do not try to open
the door if it is locked!). After you have closed
the door, press the same again.
Note!
The Delay Start cannot be selected with
«Drain» programme.
Altering an option or a running programme
It is possible to change some option before the
programme carries it out.
Before you make any change, you must pause
the washing machine by pressing button
8
.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «
O
» and then to the new
programme position. Start the new programme
by pressing button
8
again.
The washing water in the tub will not empty
out.
Interrupting a programme
Press button
8
to interrupt a programme which
is running, the corresponding light starts to
flash. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «
O
» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
button
8
. If the light
9
goes off, the door can
be opened immediately or after a few minutes
depending on the model.
If it does not switch off, this means that the
machine is already heating, that the water level
is too high. In this cases the door cannot be
opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «
O
». After a few
minutes the door can be opened
(Pay attention to the water level and
temperature!).
132962620_en.qxd 26/07/2008 12.21 Page 18
