Zanussi ZHC 929 X, Installation, Use And Maintenance Handbook

Page: 8 / 9

17 GB
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
• Replacing
Take off the metal grease filters ( fig.10 ) and
remove the activated charcoal filter from its
housing by turning the clips provided (
fig.11 ). Fit
the new activated charcoal filter and replace the
metal grease filters.
• Enabling the alarm signal
In recirculation type hoods the saturated filters
alarm must be enabled as indicated below:
• Turn off the lights T1 and the Suction Motor T2 ;
• Press and hold the button T4 for at least 10
seconds,until the Leds start to flash.Note the
number of flashes:
•
2 flashes of the LED Activated charcoal filter
saturation alarm ENABLED
• 1 flash of the LED Activated charcoal filter
saturation alarm DISABLED
• Resetting the alarm signal
To turn the alarm signal off, proceed as follows:
• Press the button T4 for at least 3 seconds, until the Leds flash in confirmation. In any
case the saturated filters alarm will only come into operation when the suction motor is
turned on.
ATTENTION - There could be a possible fire hazard if the filters are not replaced
according to these instructions.
Lighting
• Version with halogen spotlights:
90 cm model, two 20W halogen spotlights.
• To replace (fig.12)
Remove the two screws fixing the metal ring, extract
the spotlight from the lamp holder by pulling gently.
When replacing the spotlight, make sure that the two
pins are correctly inserted in the housing on the lamp
holder.
Cleaning
When cleaning the hood:
• Never use a wet cloth or sponge, or running water.
• Never use thinners or products containing alcohol, as they might damage the paintwork.
• Never use abrasive cleaning materials, in particular when cleaning stainless steel surfaces.
It is recommended to use a damp cloth and mild liquid household cleaner.
Fig. 12
Fig. 11