Zanussi ZHC 929 X, Installation, Use And Maintenance Handbook

Page: 3 / 9

12
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
GB
Installation instructions
For easy installation, proceed as follows:
• Fix the wall brackets
• Fix the canopy
• Electrical connection and working test
• Ducting or Recirculation fitting
• Fix the telescopic chimney
Fitting the wall brackets
Please refer to ( fig.2 ):
• Draw a vertical line on the wall, from the centre
of the cooking appliance up to the ceiling,
using a marking pen. This is to ensure the
correct vertical alignment of the various parts.
• Fixing the wall brackets item 2:
a) Place one of the brackets 2 against the wall
approximately 1 or 2 mm from the ceiling or
from the top limit, aligning its centre (slot) with
the vertical line.
b) Mark the centres of two keyholes in the bracket
on the wall.
c) Rest the other bracket 2 against the wall,
aligning it with the vertical line, at a distance
X measured as shown in fig. 2 equal to the
height of the upper chimney element S
supplied with the hood. The position X may
vary, according to the various sizes of upper
chimney element available.
d) Mark the centres of the keyholes in the bracket
on the wall.
• Drilling fixing holes item 1:
a) Mark a point on the vertical line at a distance
from the cooking appliances of:
d =982 min.
b) At the point marked, draw a horizontal line
parallel to the cooking appliances.
c) Drill two holes in the wall 1 using an 8 mm drill
bit (fig.2), and insert the rawl plugs and screws
into the holes 1 (4.2 x 44.4 screws). Fix the
screws, leaving a space of 5-6 mm required
to hook up the canopy. Small adjustments can
be made using the hood adjustment screws
(see Fitting the canopy). The hood should have
a maximum excursion of 20 mm.
232
260
1 1
2
260
1 1
20
232
260
1 1
2
260
1 1
20
X
d = 982 min
Fig. 2