14
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
GB
• Recirculation fitting
• The filtered air is returned to the room
through the two plastic side grills G on the
lower chimney element I .
• Connect the additional spigot
P
to the
round fan outlet, pushing it downwards,
and fit spigot
R
to additional spigot
P
in a
similar manner (make sure that the two
additional side recirculation spigots
P1
are
fitted to spigot
R
). Cut the additional spigot
P
in correspondence with outlets 1 and 2 ,
which must be formed directly on the piece.
Make sure that the height of the assembly
R
+
P
corresponds to the height of
the chimney outlet.(
fig.6
).
• Fit the activated charcoal filters
inside the canopy (see paragraph on
Maintenance
). Do not fit the venting
grilles until after the chimney has
been installed.
Fitting the telescopic
chimney
• To fit the upper section S first expand
the two side pieces slightly, hook
them behind the brackets 2 and close
them together again until they touch.
Fix the upper section S to the
brackets 2 using four of the screws
provided in the bag of accessories
(
fig. 7
).
• Fit the lower section I as above,
between the upper section S and the
canopy C using two of the screws
provided in the bag of accessories.
• Chimney with venting grilles: Snap
the venting grilles into position in the
apertures located on the chimney
section, so that the symbol
is
turned upwards and the symbol
faces forwards. Also, when the hood
is used in recirculation mode, ensure
that the grilles are properly secured
to the inside of the recirculation
spigot
R
(
fig.8
).
R
P1
P1
P
R
P1
P1
P
G
Fig. 6
S
I
2
C
2
G
Fig. 7
Fig. 8
