11
Building In
Cut Out Size
The dimensions of the cut-out are given in the diagram.
550
470
55 min.
30
Rectangular cut-out size for hob
Dimensions are given in mm.
FO 2098
ON/OFF SWITCH
FLEX
OUTLET
ON/OFF SWITCH
FLEX
OUTLET
FO 0763
FO 0764
1
2
Dimensions are given in mm.
30
20 min
60
a
b
FO 1013
3
Building over a cupboard or
drawer
If the hob is to be installed above a cupboard or drawer
it will be necessary to fit a heat resistant board below
the base of the hob on the underside of the work
surface.
It is also recommended to carry out the electrical
connection to the hob as shown in diagrams 1 and 2.
Building over a kitchen unit
with door
Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the
bottom of the hob which can be heated when it is
operated. The recommended solution is shown in
diagram 3.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical
assistance is needed. The space behind the kitchen
unit ("b") can be used for connections.
Fitting the hob to the
worktop
Before fitting the hob into the cut out, an adhesive
seal must be fitted to the underside outside edge
(Fig. 4) of the hob. It is essential that no gaps are left
in this seal in order to prevent spillage near the hob
seeping into the cabinet below.
1) Remove the pan supports, the burners caps
and crowns and turn the hob upside down,
taking care the ignition candles are not
damaged in this operation.
2) Place the sealing gasket all around the
glass top edge as shown in diagram 4.
3) Fit the hob in the cut out and push it down
until the glass top and the working top make
contact, as shown in diagram 5.
F
FO 2320
4
