Zanussi ZDM17301SA, User Manual

Page: 16 / 20

min.
550 mm
min.
443mm
100
80
min.
555mm
• Keep 5 mm distance between both sides of the
appliance and the cabinet. There are two
possibilities for the cabinet opening for the
appliance.
• Power cord, drain hose and water supply line
opening. To facilitate a proper installation,
position the opening to the right or the left of the
appliance.
ELECTRICAL CONNECTION
WARNING! Do not use an extension
cord or and adapter plug with this
appliance.
WARNING! Do not cut or remove the
earthing.
WARNING! Make the electrical
connection with the power cord.
For rating voltage check the rating
plate.
WATER DRAIN CONNECTION
max. 600 mm
• Connect the water drain hose into a drain pipe
with minimum diameter of 40 mm.
• Put the water drain hose directly into the sink.
use the special plastic support.
The water drain hose must be less than 600 mm
from the bottom of the appliance to prevent
problems during the draining phases.
Remove the sink plug when the appliance drains
water to prevent that the water goes back into the
appliance.
The extension of the water drain hose must not be
longer than 2 m. The internal diameter must not be
smaller than the diameter of the drain hose.
If you connect the water drain hose to a trap spigot
under the sink, remove the plastic membrane (A). If
you do not remove the membrane, remaining food
can cause a blockage in the drain hose spigot.
A
FINAL CHECK
Before you turn on the dishwasher check if:
• The appliance is levelled and fixed properly.
• The inlet valve is open.
• Inlet hose connections are fully tightened and
not leaking.
• The wires are tightly connected.
16