Zanussi ZDM17301SA, User Manual

Page: 13 / 20

CLEANING THE SPRAY ARM
Do not remove the spray arm. If the openings in the
spray arm are clogged, remove remaining parts of
soil with a thin pointed object.
EXTERNAL CLEANING
• Clean the appliance with a moist soft cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive cleaning
pads or solvents.
INTERNAL CLEANING
• Carefully clean the appliance, including the
rubber gasket of the door, with a soft damp
cloth.
• To maintain the performance of your appliance,
use a cleaning product designed specifically for
dishwashers at least once a month. Carefully
follow the instructions on the packaging of the
product.
• Do not use abrasive products, abrasive cleaning
pads, sharp tools, strong chemicals, scourer or
solvents.
• Using short-duration programmes regularly can
cause grease and limescale buildup inside the
appliance. Run long-duration programmes at
least twice a month to prevent the buildup.
PROTECTING AGAINST FROST
Protect the appliance from frost, for example in
winter. After each cycle:
1. Disconnect the appliance from the electrical
supply.
2. Shut off water supply and disconnect the water
inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve.
4. Connect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and
use a sponge to collect water from the sump.
REMOVAL OF FOREIGN OBJECTS
Check the filters and the sump after each use of the
dishwasher. Foreign objects (e.g. pieces of glass,
plastic, bones or toothpicks, etc) decrease the
cleaning performance and can cause damage to
the drain pump.
1. Disassemble the filters system as instructed in
this chapter.
2. Remove any foreign objects by hand.
CAUTION! If unable to remove the
objects, contact an Authorised
Service Centre.
3. Reassemble the filters as instructed in this
chapter.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
With some problems programme indicators flash intermittently indicating a malfunction.
Problem
The display
shows...
Possible solution
You cannot activate the ap-
pliance.
- • Make sure that the mains plug is connected to
the mains socket.
• Make sure that there is no damaged fuse in the
fuse box.
The programme does not
start.
- • Make sure that the appliance door is closed.
• Press the start button.
• If the delay start is set, cancel the setting or
wait for the end of the countdown.
13